ACE BACKSTAGE 224SLBR Double Wide Pocket/Std Brass Lid Brass Bezel

ACE BACKSTAGE CO., INC. extra-large sized Stage Pocket, the Double Wide Stage Pocket, is a standard general use vertical slant panel flush stage pocket. The Double Wide Stage Pocket is made of heavy duty steel and may be used to conceal audio, communications, control, data, electric AC power, switches, video, and voice connections etc. below the floor surface for easy access and to prevent connector damage. The Double Wide Stage Pocket has an extra-large capacity inter-changeable panel system which permits easy custom connector/panel configurations.

The Double Wide Stage Pocket has the panel capacity for either:
• (4) #PNL-100 Series CONNECTRIX Panels or
• (2) #PNL-120 Series CONNECTRIX Panels or
• (4) #PSW-100 Series Switchcraft® Panels or
• (4) #PE Series Single Gang Electric Duplex Switch Box Panels or
• (2) #FP3E Series Triple Gang Electric Duplex Switch Box Panels

The Double Wide Stage Pocket has the connector capacity for either:
• (24) CONNECTRIX Connectors or
• (24) Neutrik® Connectors or
• (24) Switchcraft® Connectors or
• (12) CONNECTRIX, Neutrik®, or Switchcraft® Connectors and (2) #PE Electric Duplex Switch Box Panels

Utilizing ACE's CONNECTRIX System will allow mounting of up to 24 CONNECTRIX, Neutrik®, Switchcraft®, and/or Custom Connectors in the Double Wide Stage Pocket. All ACE Double Wide Stage Pockets are welded steel construction, with a 1/8" (nominally 10 ga. (.135")) thick CRS steel Lid, a 1/8" (nominally 11 ga. (.120")) thick CRS steel Mounting Flange, and a 16 ga. (.062") thick Pocket Body. The Double Wide Stage Pocket resists bending under even the most severe stage loads.

Removable spring loaded hinge pins permits easy exchange of lids for carpet lids, locking lids, standard lids, and other custom application lids. A generous cable way slot of 3/8" x 16" permits easy cable exit from the stage pocket, even for large gauge cables. Two cableway slot channel closures closes the slot when not in use. The Double Wide Stage Pocket has an easy installation into 16.8" x 8.5" cutout in the stage floor. Open easy access from top or back of the Double Wide Stage Pocket to connector panels makes for easy installation.

A scratch/wear resistant finish, oven cured powder coat is electro-staticly applied inside and outside the entire Stage Pocket. Decorator neutral Antique Copper Vein or Textured Black finishes are standard. A Solid Brass Lid and Mounting Flange as well as Solid Stainless Steel Lid and Mounting Flange are also available by special order. The Double Wide Stage Pocket's solid rubber Lid Stops cradle the lid to prevent lid rattle.


• Double Wide Stage Pocket Body Size = 16.000” W x 4.500” H x 7.187” D
• Double Wide Stage Pocket Lid & Mounting Flange Size = 18.500” W x 0.937” H x 10.500” D
• Double Wide Stage Pocket Connector Capacity = Up to 24 CONNECTRIX, Neutrik®, or Switchcraft®
• Double Wide Stage Pocket Cutout Dimensions = 16.800" W x 8.500" H
• Double Wide Stage Pocket Material = CRS Steel and/or Solid Half Hard Brass
• Double Wide Stage Pocket Panel Capacity =
• (4) #PNL-100 Series CONNECTRIX Panels OR
• (4) #PSW-100 Series Switchcraft® Panels OR
• (4) #PE Series Single Gang Electric Duplex Switch Box Panels OR
• (2) #FP3E Series Triple Gang Electric Duplex Switch Box Panels OR
• (2) #PNL-120 Series CONNECTRIX Panels